Plug your VX360 to your Tesla or at Home

To set up your VX360, plug it into your Tesla’s glovebox USB port, a USB charger at home, or directly into your computer and wait 30 seconds for the device to boot.

1. Tesla's Glovebox:

Tesla's Glovebox

If you plugged your device into your Tesla’s glovebox USB port, a dashcam icon should appear on your screen with a grey or red dot. More information here.

If the dashcam icon doesn’t turn grey or red: unplug and reconnect the VX360. If the issue persists, try using a different cable.

If an alert appears on the top right of your Tesla dashboard asking you to unplug and replug the VX360 device ""Re-insert USB into glovebox for higher speed" ", you can safely ignore it.

Your VX360 device will continue to function normally even if this message appears.

2. At Home with a usb charger or into your computer:

USB charger at home or directly into your computer

3. Where to plug your VX360 device:

Depending on the task, your VX360 should be plugged into either your Tesla or a power source at home:

  • Collecting Footage: To collect footage, plug your VX360 into your Tesla while driving.

  • Configuring the Device: You can configure your VX360 by connecting it to your Tesla or to any 5V power source at home.

  • Uploading Footage: To upload footage, keep your VX360 plugged into your Tesla if it’s within range of a saved Wi-Fi network, or connect it to a power source near your home Wi-Fi router.

Last updated